|
|
||
|
|
|
|
This and the next image are from::
Anila Laszlo Joó and Sandor Adány (Department of Structural Mechanics, BME, Muegyetem rkp. 3. Budapest, H-1521, Hungary),
“FEM-based approach for the stability design of thin-walled members by using cFSM base functions”, Periodica Polytechnica, Vol. 53, No. 2, pp 61-74, 2009, doi: 10.3311/pp.ci.2009-2.02
ABSTRACT: This paper presents a new design approach for the stability design of thin-walled members. The proposed approach is based on the buckling modes and critical forces/moments determined by a linear buckling analysis performed on a regular shell finite element model. A fully automatic buckling mode identification technique is applied, by using the modal base functions of the newly proposed constrained finite strip method, where the various buckling types are separated by clearly defined mechanical criteria. The paper briefly summarizes the determination of modal base functions which then are used to approximate finite element displacement functions (i.e., buckling modes). The mode identification method provides the lowest critical values (forces or moments) to all the three characteristic buckling types: global, distortional and local, on the basis of which the buckling resistance can be calculated by using the design formulae of the direct strength method. The proposed new approach, which is potentially more general than any of the existing design approaches, is demonstrated on Z columns and beams with simple loading and boundary conditions. Critical values as well as resistances are calculated for some selected cases, the results are compared to those of another design method. The comparisons prove the applicability of the proposed procedure. Further research is necessary to extend the proposal for more general and more complex practical cases.
Page 59 / 114